Quantcast
Channel: Automotive Repair Manual Download and Reviews » Search Results » how to change fog light on ford focus 2013
Viewing all articles
Browse latest Browse all 10

2005 Honda Civic Hybrid Fog Light Installation – Page 2

0
0

Installing the Fog Light

Fog Light23. Push the boss of the left Fog Light into the outlet within the entrance bumper, made in step eight, then match the left Fog Light into place on the left of the entrance bumper.
24. Below the front bumper, install the washer-bolt to safe the left Fog Light to the front bumper.
25. Repeat steps 23 and 24 to put in the proper fog light onto the bumper.

Routing the Fog Light Subharness

26. Remove the six clips and two self-tapping screws, and pull the appropriate (passenger’s) side front interior fender down in the direction shown.
27. Inside the best front inside panel, locate the rubber grommet. Push the grommet out and into the passenger’s compartment. Route the subharness into the passenger’s compartment, and seat the harness grommet within the panel hole.
28. Route other end of the subharness by means of the inside fender towards the front of the vehicle. Plug the subharness 1-pin connector into the fog light harness 1-pin connector routed in step 14.
29. Near the 1-pin connector, safe the fog light harness to the car harness with one wire tie within the area shown. Attach the subharness to the inner fender panel with two additional wire ties with clips from the equipment, and the one harness clip already hooked up to the subharness. Insert the clips into the empty holes within the inside fender panel.
30. Reinstall the fitting (passenger’s) aspect entrance interior fender.
31. With the assistance of an assistant, join the fog light harness 2-pin connectors to the appropriate and left fog lights, and reinstall the entrance bumper.

Routing the Fog Light Switch Harness

32. Contained in the passenger’s compartment, take away the dashboard lower cover on the driver’s side. Turn the 2 knobs counterclockwise, and launch the four retaining tabs.
33. Flip the knob counterclockwise, and launch the 2 clips, and take away the driver’s dashboard beneath cover.
34. Remove the higher and lower column covers (three washer-screws, six retaining tabs).
35. Take away the driver’s pocket (one self-tapping screw and two retaining tabs). If equipped with a change, open the pocket, remove the self-tapping screw to launch the panel, and disconnect the harness from the switch.
36. Take away the precise (passenger’s) facet kick panel (two clips).
37. Remove the escutcheon, and center console trim.
38. Take away the center lower trim (two self-tapping screws, nine clips, one retaining tab, and unplug the accent socket connector).
39. Open the center console lid, and take away the mat.
40. Remove the brake lever trim, and take away the center console (two self-tapping screws, three washer-screws and two clips).

Page 1 | Page 2


Viewing all articles
Browse latest Browse all 10

Latest Images

Trending Articles





Latest Images